A pair of metal saw horses whose legs extend far higher than most, running from 31.5 inches at the lowest setting up to 51.5 inches at the top through six locking levels. That upper reach is what makes them useful beyond bench work: at full extension the pair holds a door or a sheet at chest height for planing, sanding, or hardware fitting, so the work comes up to the hands rather than the back bending down to meet it. Dropped to the low setting, the same horses become a conventional cutting platform. Combined capacity is 440 lbs across the pair, carried by metal tube construction that resists flexing when the load shifts. Top limit clips grip the beam being supported, adding control so a board cannot slide sideways off the crossbar mid-cut, and triangular side structures brace each leg pair against racking, which is the failure mode that matters most on a horse extended to full height. Non-slip pads at each foot bite the floor and keep the frame from walking under vibration. Both horses fold to 27 by 5 by 33 inches for carrying and storage, and the pair weighs 23 lbs in total, so a single trip moves the setup between sites. Assembly is required. They suit contractors, carpenters, and DIY users working in a workshop, a factory, or wherever a temporary support has to go up and come down the same day.