A 50-quart rotomolded hard cooler in gray, molded from LLDPE in one seamless piece so there are no glued seams to split after a few seasons of hard use. The 27-by-14.5-by-16.5-in shell holds a 22-by-11-by-13-in interior, deep enough to stand bottles upright instead of laying them on their sides, and the whole chest weighs 22 lbs empty. Thick insulation and a sealed lid keep contents cold or fresh for five to seven days, and the same construction works in reverse, holding warm food for two to three days. Sealing comes from rubber latches that pull the lid down onto a full-perimeter gasket, so meltwater stays inside rather than tracking across a car trunk or a boat. When the ice finally goes, a fast drainage plug empties the chest without tipping 50 quarts of water over anyone's feet. The lid is rated to hold 220 lbs, which makes it a small table while camping or an extra seat when the chairs run out, and non-slip rubber foot pads keep the cooler planted while someone is sitting on it. Cup holders, a fish ruler, and a bottle opener are molded into the body, so those items are not one more thing to pack or lose. Handles on both ends let two people carry a full load, and the 50-quart capacity covers travel, beach days, boat trips, fishing, and camping without a second cooler riding along.